We offer a wide variety of configurations to choose from, allowing for you to easily personalize your dock Whatever you are looking for, we should be available to custom build it since we build what we sell.
Docks can run straight out into the lake or they can easily run along sea walls
Our anodized docks come in 3'x10' or 4'x10' sizes. They stay cool in the sun and do not weather and oxidize like mill finish aluminum docks will. The anodized finish also helps reduce glare from the sunlight. These docks are also very light and strong, while having completely welded frames.
4'x10' is $450 per section (Two stringers)
3'x10' is $340 per section
These docks are offered in 3' and 4'x10' sizes as well. They are very light and have welded frames.
4'x10' is $325 per section (Two stringers)
3'x10' is $240 per section
We have steps that attach to your dock to make getting out of the water much easier. Available in 3 Step, 4 Step and 5 Step.
3 Step $400 26"- 32"
4 Step $475 33"- 39"
5 Step $535 40" - 46"
Each dock has a completely welded frame. The 4'x10' docks have two tubes running lengthwise and two running widthwise as shown above. A lot of the competition only has one tube on the 4' docks. The 3'x10' docks have one tube running lengthwise and two running widthwise.
These supports are made of 2" aluminum tube with aluminum clamps and brackets. Each pole comes with a cap to provide a finished look. The legs come standard with 1' aluminum mudplates. The clamps allow for very good adjustability
Complete pole sets start at $125
Our platform setups are made out of 1.5"x5" aluminum tubing. These supports are very strong and use heavy duty 10 inch clamps to keep it as sturdy as possible. 1' mudplates are also standard here. Starting at $269
These clamps are made of stamped aluminum, so they will not crack like cast aluminum clamps. These clamps are made for 2" OD tubes.
$15.00 each set of 2 pieces and nuts and bolts included.
These brackets are made of extruded aluminum so they also are made for durability and will not crack like cast aluminum. They are made for 3/8" carriage bolts. They are made for 2" OD tubes.
These plastic pole caps are made for 2" OD tubes and add a finished look to the dock.
Our crossmembers have the aluminum clamps and brackets included and have a 2" OD center tube.
All pole sets come standard with 1' mud plates. They have galvanized nuts and bolts.
The augers above are made of composite plastic which makes them much less prone to cracking unlike cast augers. They are made for 2" OD tube
These come in 35.25" or 47.25" widths. Platform crossmembers can also be purchased. They are adjustable and can be had large enough for up to four 4' docks.
$110.00 for 3'
$115.00 for 4'
We love our customers, so feel free to give us a call to set up an appointment
500 Collins Road, Elkhart, Indiana 46516, United States